Installing the keypad is very easy. Place your original remote next to copy remote. Hold both buttons down until you see led on copy remote flashes quickly.
The Screw Should Be Installed So That The Head Is Slightly Away From The Finish Surface (1/8 Inch).
With your other hand, press and release the yellow learn lrn button on the front of the opener. We wanted to make sure that when you are installing a diy genie garage door opener, the instructions are easy to follow, understandable, and you enjoy getting the job done. Hold the button for about 6 seconds and watch for the light to go out.
Once The Light On The Opener Is Flashing, Press The Open Button On Your Garage Door Opener Remote.
They need to be close to each other so they can link up. Looking for easy, coded access through your garage door? Use 1 hand to work your current garage door remote, and the other to push the control buttons on your car.
To Exit Programming, Press And Release Any Remote Control Button Except The Button That Was Just Programmed.
Avoid using the old components such as the sensors. A way to test this is by standing within 20 feet of the door, press the remote control and see if the garage opens. Press the open button on the remote unit within 30 seconds to program the motor housing unit.
Climb Down From The Ladder And Move At Least 5 Feet From The Motor Housing Unit.
Wait until a light flashes in the opener. Lift the other end of the assembly up and into place. Hold your current garage door remote 2 in (5.1 cm) from the control.
Press And Hold The Button On The Remote Control Handset.
Press and release the button on the clicker remote control you want to operate the garage door opener. I drilled mine a bit to large, but was still able to make it work easily enough. Press and hold your remote button and one of the homelink buttons.
